Engagement of the feedroll is done by pushing or pulling the handle that wraps around the outside of the feed box. The feedroll has three positions: neutral, reverse, feed (forward).
The feedroll grabs the material as it is fed into the chipper and allows the operator to step away while it automatically pulls material into the knives.
The hydraulic feedroll is mounted on a spring-loaded frame on the WC12 Series Wood Chippers, allowing it to raise up and down depending on the size of the timber going through.
The speed of the feedroll can be adjusted on the side of the wood chipper with the hydraulic flow valve.
The discharge chute rotates 360 degrees for fast and easy positioning.
The chute also features an adjustable deflector to accurately direct the wood chips to the desired location.
The WC1208 features a heavy-duty drum to make quick work of large chipping jobs.
The drum is designed to maintain a constant speed so material can be continuously fed into the feed box while creating a consistent chip size.
The Frontier© WC1208 is equipped with a sturdy frame and transport wheels, and the clevis-type drawbar makes attaching the unit easy.
It features a hose holder to conveniently hold hydraulic hoses for storage. It comes standard with a jack and safety chain.
This factory-installed, self-contained hydraulic kit is for tractors with less than 22.7 L/min (6 gpm) of hydraulic capacity or with no available rear selective control valves (SCVs). The kit contains a hydraulic reservoir and power take-off (PTO) driven hydraulic pump.
|Chip opening||229x406 mm
|Hopper opening||711x1067 mm
|Feed_x001A_roller diameter||393.7 mm
|Hopper height||68.6 cm
|Adjustable||Rotation: 360 degree (angle)|
|PTO rpm||540 rpm|
|HP range (Tractor PTO hp)||56-86 kW
|Knife size||1.59x11.43x22.86 mm
|Knife bolt||Gr 8 hex head bolts: 15.9 mm
|Shear bar||A8 Hardened Anvil|
|Rotor rpm||2050 rpm|
|Belt drive system|
|Type||B-7 banded belt|