| Disk blades | / |
| Frame | / |
Scrapers clean disk blades
Scrapers work great in wet and sticky soils
Adjustable disk blade scrapers keep disk blades clean and performing in wet and sticky soils for increased productivity.
Keeping gangs tightened increases wear life
Gang nut wrenches are always there when needed
End washers help keep the gang shaft end nut tightened during operation, increasing gang wear life.
Two gang nut wrenches are supplied with each unit and securely attached to the unit, ready to use when the gangs need tightening.
Transport locks secure disk wings cylinder
Transport locks are standard, ensuring disk wings are in secure transport mode.
Control arms level in ground and during transport
Easy to set for desired soil condition
Two separate control arms are standard, one for transport leveling and one for leveling while the disk is in the ground. Once set for a given soil condition, the disk will continue to perform with consistency.
Minimal maintenance increases work hours
Sealed with industrial-grade seals
Oil bath tapered roller bearings, sealed with industrial-grade seals, keep maintenance to a minimum and profitable working hours at a maximum. The bearings come complete with a wear plate.
Transport locks secure disk wings cylinder
Transport locks are standard, ensuring disk wings are in secure transport mode.
| Transport | |
| Width | 3.4 m 11 ft |
| Wheel hub bearings | Dual tapered roller bearings |
| Working | |
| Approximate working width | 3 m 10 ft |
| Weight | |
| Net | 6,304.9 kg 13,900 lb |
| Weight per disk blade | 393.7 kg 868 lb |
| Tractor requirements | |
| Recommended drawbar hp range | 167.8 kW 225+ hp |
| Tires | |
| Type | 2 - Radial Industrial |
| Frame | |
| Duty | Heavy |
| Tube size | 20.3x20.3x1.3 cm 8x8x0.5 in. |
| Hitch | |
| Front hitch type | Pintle |
| Disk blades | |
| Spacing | 43.2 cm 17 in. |
| Quantity | 16 |
| Available blade sizes | |
| Blade option one | 914x12.7 mm 36x0.5 in. |
| Disk gangs | |
| Front angle | 3 positions |
| Rear angle | 3 positions |
| Axle size | 6.4 cm 2.5 in. |
| Axle material | Round heat treated alloy steel threaded on both ends |
| Bearing type | Oil bath tapered roller |
| Bearing wear plates | Standard |
| Bearing standards | Welded, reinforced |
| Scrapers | Adjustable |
| Lighting and safety | |
| Markings | SMV |
| Safety tow chain | Yes |
| Lights | Yes |
| Tires | |
| Size | 385/65R22.5 |
| Wheel hub type | 5-spoke Dayton hubs |
| Set-up time | |
| L | L |
| Warranty | |
| w | w |
| Key Specs | |
| Disk blades | |
| Frame | |