The rotor bearings are now made of steel and have a three-lip seal to keep the dirt out and increase the life of the bearings.
The side and center bearings now have guards in order to avoid leaks and dust, increasing the life of the bearings.
The 100 Series Flail Shredder is available with a drawn tractor hookup.
A heavy-duty gearbox transfers power to the power-band drive belts through cross shafts with intermediate bearing supports:
Front rubber deflectors keep debris and other materials under the shredder and away from the tractor and operator. Because they are made out of rubber, they will not dent or rust.
|Cutting width||6.1 m
|Cutting height||7.6 to 25.4 cm
3 to 10 in.
|Transport width||2.4 m
|Transport length||7.3 m
|Belts||Power-band, triple 5VX|
|Number of knives||160|
|Knife mounting system||7.87 x 63.5 x 143 mm
0.31 x 2.5 x 5.63 in.
|Type||Heat-treated, reversible, side-slicer, hard-faced, tungsten-carbide knives optional|
|Tip speed||171 km/h
|Hood thickness||6.35 mm
|Gauge wheels||7.60-15 infinitely adjustable row spaces|
|Constant velocity joint driveline||Yes|
|Tractor PTO hp range||67-200 kW
|Tractor RPM||1,000 rpm|
|Bearing size||41.15 mm
|Rotor speed||1,500 rpm|
|Rotor diameter||139.7 mm
|Rotor bearing||Sealed, self-aligning; piloted housing, auxiliary seals, and grease cavities|
Deflectors can be used on the front of the shredder to prevent cut material from being thrown forward. Rubber deflectors are recommended when shredding in rocky areas.
Additional gauge wheels can be ordered, if needed, for improved cutting performance.
Transport warning lights are standard on the 520 Integral Flail Shredder and optional on the 520 Drawn Flail Shredder.